How to configure zone in brocade san switch

This operation requires that the affected ports be disabled. Port 6 for example, as shown in the figure above.

Lets also switch context to FID8 when configuring the ports for the base switch by FID128:admin>setcontext 8Д¬onfigure the port for the base switch. Please configure the Logical Switch with appropriate switchДЄnd protocol settings before activating the Logical Switch.ДЇID 8 is created, so letвЂ™s assign some ports. Logical Switch has been created with default configurations. Logical Switch with FID (8) has been successfully created. FID128:admin> lscfg -create 8 -baseД¬reation of a base switch requires that the proposed new base switch on this system be disabled.ДЄbout to create switch with fid=8. You can see in which FID context you currently are in the identifier in front of your username. Notice weвЂ™ve got a default fabric 128 after enabling VF. WARNING: This is a disruptive operation that requires a reboot to take effect.ДЄll EX ports will be disabled upon reboot. Warning though!! The switch will reboot immediately after hitting вЂњYвЂќ admin> fosconfig -enable vf ISNS client service: Service not supported on this PlatformД®thernet Switch Service: Service not supported on this Platform ISCSI service: Service not supported on this Platform I read in the manual, VF would be enabled by default. Only ISL ports can be configured in the base switches. Lastly, the base switches will form fabric 8, but this is a special XISL only fabric.Logical switch 3 and 7 will form fabric 15.Logical switch 2 and 6 will form fabric 1.Logical switch 1 and 5 will form the default fabric.The XISL will take care of the вЂњtrunkingвЂќ of the fabrics on either sides. The XISL is using LWL SFPs for the 10KM distance.

How to configure zone in brocade san switch